- Laserlite 3000
- Laserlite 2000+
- Laserlite 1000
- Laserlite 2000+ Twinwall
- Custom Glaze NEW SIZE
- Crystalite Glazing Panels
- Skylite GRP
- Sunshade PVC
- TwinWall 5 Rib
Sunshade PVC roofing sheets are a corrugated translucent roofing product designed for weather protection and enhancement of your outdoor living area.
Storage, Handling and Maintenance
Because sheets at the top of a stack will act as a magnifying glass, it is essential stacked sheets are stored away from direct sunlight as heat build up will distort stacked sheets.
Sunshade is a low cost PVC roof sheeting product and as New Zealand experiences high levels of Ultra Violet light, in certain conditions some installations can reduce the useful life of the product.
Correct installation of Sunshade PVC begins with placing the sheets in position and pre-drilling of a 10mm oversize hole. This allows for sheet expansion and contraction and will enable the sheets to sit straight avoiding distortion from over tightening on the purlins.
Sunshade PVC roofing can also be installed for use in a variety of roofing, cladding and fencing situations. Sunshade PVC roofing is available in Opal (610mm) frost tint and Clear (760mm) that provides shade from sun, rain and wind, can easily be cut to measure and is available in four handy sheet lengths.
1800mm, 2400mm, 3000mm and 3600mm
SUNSHADE CLEAR 760MM EFFECTIVE COVER
Sunshade Clear 860mm wide sheets effectively cover 760mm. 860mm wide corrugated iron or pre-painted roofing supplied into the New Zealand roofing market are 860mm wide sheets. Therefore 860mm Sunshade will replace old sheeting where the iron on the structure is 860mm wide, therefore leaving a gap of 760mm. Be aware Opal 690mm wide PVC sheets will not fill this gap.
Sunshade Opal 690mm wide PVC sheets do not carry any specific warranty and it is recommended these sheets are replaced after 3 years.
Sunshade Clear 760mm wide PVC sheets do not carry any specific warranty and it is recommended these sheets are replaced after 3 years.